Genesis cast block #118 has arrived!

slithering · #1 (**permalink**) 05-14-2004, 08:39 PM

My Genesis block arrived today from Keith Craft and company, WOW! Very impressed with the beefed up casting, and the machining from Keith. I gave him specifics as to the build of the block and he did everthing as I asked. We waited a while for the block, as soon as he received it, he contacted me and they had the block done in a week. Keith was always honest with me and did a superb job on my block. Shelly was very patient with my concerns and calls. I would do buisness with them again in a second. The block goes to the powder coater tomorrow and then off to final machining. Can't wait to hear this run!

Chris

JRoss · #2 (**permalink**) 05-15-2004, 09:35 PM

Chris,

What kind of build are you planning.

John

slithering · #3 (**permalink**) 05-16-2004, 01:26 PM

John,

I'm using a Edlebrock performer power package, low/medium-rise manifold, 427 hp rods, KB pistons with Total Seal rings, Edlebrock Thunder Series 800 cfm carb. Tranny's a Tremec 3550 TKO with a 9" rear and 350 gears. I am using an Evans Cooling system. Hope to have it running next weekend, if the powdercoting on the block is done in time. Everything else is pretty much done, paint is last.

Chris