CNC Slave Cylinder Question - Please Help!!

Juggernaut · #1 (**permalink**) 11-03-2007, 10:15 PM

Hoping someone can help me with this one as so many forum members has helped me out before.

I need to get a bracket to mount my CNC push type slave cylinder to the side of a 1984 T5 tranny so it pushes the fork forward, does anyone know where I can get a bracket?

I did a search on the subject but wasn't very successful.

Thanks in advance,
Randy

Badger · #2 (**permalink**) 11-04-2007, 01:32 AM

Check out any good racing team in your local area. Someone on that team has to know a good fabricator. A really good bracket that is properly measured an built correctly could easily take two hours. At $80 an hour the bracket should cost about $160 bucks. Expensive? yes, but done right you won't have any more problems. Badger

COBRAGAR · #3 (**permalink**) 11-04-2007, 05:18 AM

THE BRACKET THAT YOUR LOOKING FOR IS AT WWW.DAZECARS.COM IT'S ABOUT 55.00 DOLLARS PLUS FREIGHT . REMEMBER YOU STILL NEED THE PUSHROD AND HALF MOON WASHER AND GOOD RETURN SPRING .I HOPE THIS HELPS I USE IT AND IT WORKS PERFECT. HOPE THIS INFO HELPS YOU. IF YOU CANNOT FIND IT EMAIL ME .

Juggernaut · #4 (**permalink**) 11-04-2007, 05:59 PM

Thanks guys for the responses!

COBRAGEAR - I'll be contacting Daze Cars for the bracket I need.

Once again, thanks for the help. Another problem solved!

Randy