Master cylinder (clutch)

Coobra · #1 (**permalink**) 09-13-2006, 05:37 PM

Curious.......I changed my slave to a larger unit from Fortes. The master Joe suggested is too small. (5/8") Anyone else have this issue and if so what master did you use? I ordered a new master from Mike, no doubt I will have to make it fit...........

pgermond · #2 (**permalink**) 09-13-2006, 07:38 PM

Check this topic - Clutch Master /Slave Problem

Automan · #3 (**permalink**) 10-18-2006, 12:13 AM

I just ordered my clutch master and slave cylinder for my AC. I ordered the parts that were listed in the manual. The Nissan slave and the Honda master cylinder. I hope they work. I seen the picture of the slave cylinder and i can see how it is able to touch the fork mounted on the inside of the frame. Just no to sure how close i should put it near the fork.

Automan