Drive Shaft

[martrogers]

Merv

This is what I found out when I did mine. I assume yours will have 2 universal joints and a spline. Mine was made from standard joints which can be replaced when worn without having to have the whole thing re-fabricated. Also will need balancing of course. Mine has worked out well, I cannot feel vibration at any speed.







Martin

[martrogers]

I should have mentioned that my rear is an IRS which means my angle stays constant, if yours is not an IRS you will need to take the range of angles into account, there are various tables and calculators on the web which relate maximum shaft RPM to allowable angle.