Speedo Cable Routing

[jams]

Hi Guys,

What is the best route to take for the speedometer cable once it leaves the back of the speedometer? Does it need to go through the firewall and loop under; can it run through the gap where the firewall meets the trans tunnel? Any suggestions would be greatly appreciated.

Getting close to turning the Key!!

Jim

[Whaler]

I too am pondering that as well. I am using the reverse winding speedoi adapter which puts its at a 90 right angle as well...so it exits the speedo and heads either down or across not straight our to the footbox wall

Tim

[BS12756]

If I remimber it turns right in back of the eng and goes aft, there will only be a slight turn becuase the cable is just long enough to reach, it will not evan touch the engine. good luck

BS

[Clois Harlan]

I ran mine to the top right of the passenger foot box, split a firewall gromett and siliconed it to the lower firewall. Then I ran it down the frame rail and attached it with rubber clamps. Doesn't touch anything.

Good luck.