04-26-2003, 03:07 PM
|
|
CC Member
|
|
|
Join Date: May 2001
Location: Oak Forest, IL,
IL
Cobra Make, Engine: B&B w/FRPP 347ci 450HP Crate
Posts: 896
|
|
Not Ranked
Mounting Sube Classic Seats
I am contemplating just mounting the Sube Classics that I have. I have the sliders, and am open to mounting with or without them. If I center the seats on the stearing wheel and where the look best, I can get one bolt into the steel frame with the sliders. The rest would be into the fiberglass, and I would need to run a bolt up with a metal spacer sleeve for the bolt that goes directly over the foot pan.
For some reason, mounting to the fiberglass does not seem sane to me, although I know that some have done it.
Also, if I go this route, does anyone have any suggestions for mounting the simpson lap belts? On the out sides, I could go through the 2X3 outrigger. On the inside, I do not know what to do. I do have the B&B seat mounts, but they are not installed. With these, the Sube's would be way to high.
Thanks,
Tom
|
Linear Mode
