11-11-2010, 04:29 PM
|
 |
CC Member
|
|
|
Join Date: Nov 2009
Location: Clayton,
NC
Cobra Make, Engine: BackDraft Racing 351W bored and stroked to 427 hydraulic full roller
Posts: 54
|
|
Not Ranked
Quote:
Originally Posted by Mac VABCH
Hitch,
I put in a Hydraulic Throw out Bearing a few years ago an haven't had any issues. I have a Quarter Master HTB. I did have to machine the input shaft bearing retainer to fit, not a big deal 10 minutes on a lathe... you didn't say, but did you have a drive shaft safety loop installed? I'm asking because I'm contemplating using a carbon fiber drive shaft so if it does break it won't cause to much damage. But if the safety loop stood up well then I won't...Mac
|
Mac thanks for the info on the HTB. As for the driftshaft loop I don't have one however I'm not sure that it would have done much good. With the DS only being 10" long it can't go to far. It seems every loop I've seen is pretty large to be effective it would need to be a small loop.
Dave |
Linear Mode
