06-26-2007, 11:14 PM
|
|
CC Member
|
|
|
Join Date: Aug 2003
Location: San Diego,
CA
Cobra Make, Engine: BDR #455, KC427W, TWM-FI
Posts: 727
|
|
Not Ranked
Suspension tuning
Trying to get my alignment correct and need advice.
I need to get more adjustment out of the rear lower control arms. Track is more than an inch out. Is it better to elongate the holes or to buy the adjustable arms? Should I get the solid or bushing type?
http://www.akgmotorsport.com/e36products.html
I need to take some camber out of the front (I'm at -3 on each side) I don't want to adjust my ride height up to do this. Do the aftermarket camber plates for BMW work on a BDR frame? (I think someone before said the top brackets on the frame might not be wide enough.) Is there another way to do this?
http://www.ground-control-store.com/...?offset=0&CA=9
Finally, where is the best place to get SS brakelines. Jay do you have any in your store/shop? I purchased some for a E-36...that was a mistake they are super short with no way of reaching!!
Thanks,
Rob
Last edited by Rwillia4; 06-26-2007 at 11:25 PM..
|