Roll bar template

HPCOBRA · #1 (**permalink**) 11-02-2010, 07:32 PM

Does any body have a copy of the original template supplied with the factor CR Roll Bar?
Thanks

JEwalt · #2 (**permalink**) 11-02-2010, 10:13 PM

I went through my complete manual and did not find a template for the roll bar. The manual referrs to markings on the body itself (and the new body I recently received for my re-construction has such markings) indicating where a 1 7/8" hole should be drilled for the roll bar. I can send you the pages of the manual discussing (w/fotos) the assembly process.

Jeff

HPCOBRA · #3 (**permalink**) 11-03-2010, 07:48 PM

Another member sent me copies of their manual which covered pages 5-18 thru 5-23. If you have something other then that, then I would really appreciate it. My body has no markings on it. The body has no paint, but it has been primed and blocked a few times. Thanks again

Double Venom · #4 (**permalink**) 11-04-2010, 12:05 PM

Just a note!***** be careful of roll-bar templates, even if they are CR's! Every bar I have installed has always been bent different by a degree or two.

Mine TOO.... as much as I try and duplicate them exactly EVERY bar is different to some 'degree'. Mostly because every piece of steel / tube has to be bent "past" where you want it, to allow for spring back! Some more than others!

JEwalt · #5 (**permalink**) 11-04-2010, 10:59 PM

You have the same pages as my manual; however, DV is right. Also, you have to consider that each body may sit/be mounted to the frame in a slightly different position.