CR Parts needed

[Comanche]

Hi, I am in need of a few parts for final completion of a CR. Any help in ideas or sources for these would be greatly appreciated. I am down to resorting to just fabrication if necessary but would prefer to use something more original if available. Also could really use a wiring schematic copy if available. Not having a manual or having actually seen a completed CR, other than just vague pictures,I'm not sure of exactly what the original components looked like. Thanks for any help., Parts as listed:
1). complete hood hinge mechanism, including hinges and however they connected to the radiator hoop mount.
2). Radiator "hoop" mount frame and up thru hinges
3). Also alum. radiator ( Best source ideas ) for 500+ hp.
4). Wiring schematic copy
5). Any graphic picture copy of above parts from assembly manual
Thanks, Ronnie

[tcrist]

Ronnie,

I have an old build manual that you can have. Pm me your address and I can get it in the mail.

Also, you can check out my photo gallery for a few build picks if you want.

[CobraEd]

Where is DV ?????????????????? Does anyone know him well enough to call? He has been MIA for at least two weeks!!!


.

[G_Edmonds]

Ronnie,

I assume you looked at CaptEddie's build at one time or another. Another good source of information with lots of photos is:

http://www.kdomus.com/petek/cobra/

-Greg

[Comanche]

Thanks so much Terry. Hope you got my PM.
Ronnie

[Comanche]

Same here Cobra Ed....I've been corresponding with him a couple weeks through email and now as you said.....MIA. Hope everything and everybody is well.

[Comanche]

Greg, Thanks for the info. I have been referring to both of those sources once in a while,and getting a little insight into some of what I need.
Thanks again, Ronnie

[tcrist]

DV has been accessing the forum but I have not seen too many posts as of lately. I believe he was on the forum as late as this morning.

Ronnie,

I did receive you PM and your e-mail.