One of my side pipes is slightly too close to the body and is rubbing. Does anybody know if there is an off the shelf spacer that I can get? Also, where can an additional gasket be found? I can have the spacers made if necessary. I noticed Finish Line has gaskets and flanges (Maybe could be used as a spacer?) Just wondering if they fit CRII's. Thanks for any help.
Cobra Make, Engine: Lonestar LS 427, Keith Craft 501,Toploader
Posts: 883
Not Ranked
Just use an extra flange and don't use a gasket, use a high temp silicone sealer. Doesn't have/need to be for a CR II, just use a dremmel or grinder to match your flange.
Spacer for between header and side pipes
Linear Mode
