Wiper install instructions

Ferguson · #1 (**permalink**) 04-10-2013, 10:14 AM

Hi all.recently purchased a 68 Cobra made in 1999 by Classic roadster in Fargo ND . Just wondered if anyone had some wiper install instructions and or pics they could share. Purchased the kit from Finishline. I have a call in with them also. Thank you

JEwalt · #2 (**permalink**) 04-10-2013, 02:46 PM

Look at the motor, you will see one of the wires is blue. Disconnect it from the plug and take it to ground. That's it, it should work fine.

tcrist · #3 (**permalink**) 04-10-2013, 04:56 PM

Do you have the manual? The "limited" instructions are there with some pictures.

Double Venom · #4 (**permalink**) 04-12-2013, 05:26 AM

If you don't have the manual, let us know. I might be able to dig up the instructions. As crazy as it sounds 'JEwalt' is right on! remove, cut the original wire (blue) and take it to ground. The mounting case works just fine.
DV

Ferguson · #5 (**permalink**) 04-14-2013, 05:29 PM

Thanks all. I appreciate the input. Finshline emailed them to me. Thanks

Double Venom · #6 (**permalink**) 04-15-2013, 05:57 AM

Ferguson,
I Think (?) what finishline is sending you is a instruction sheet and/or a wiring schematic for a basic install. It is not the same as CR's install by any means, nor is their wiring schematic compatible with CR's. Can be mighty confusing for the un-informed. Just thought you might want to know.........
DV

Ferguson · #7 (**permalink**) 06-08-2013, 01:57 PM

Thanks everyone for the input. Install went well,but time consuming. Used steel 5/16 fuel line between the pivots. Tried using the plastic line as was recommended,but it couldn't contain the drive cable.