Main Menu
|
Nevada Classics
|
Advertise at CC
|
S |
M |
T |
W |
T |
F |
S |
|
|
|
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
9 |
10 |
11 |
12 |
13 |
14 |
15 |
16 |
17 |
18 |
19 |
20 |
21 |
22 |
23 |
24 |
25 |
26 |
27 |
28 |
29 |
30 |
31 |
|
|
CC Advertisers
|
|
20Likes
02-19-2021, 05:57 AM
|
|
Senior Club Cobra Member
|
|
|
Join Date: May 2001
Location: Florence,
AL
Cobra Make, Engine: RCR GT 40 & 1966 Fairlane 390 5 speed
Posts: 4,511
|
|
Not Ranked
welcome Larry
enjoy the madness
__________________
''Life's tough.....it's even tougher if you're stupid.'' ~ John Wayne
"Happiness Is A Belt-Fed Weapon"
life's goal should be; "to be smarter than inanimate objects"
|
02-19-2021, 06:22 AM
|
CC Member
|
|
|
Join Date: Jan 2021
Location: Worcester,
pa
Cobra Make, Engine: 2007 Superformance
Posts: 13
|
|
Not Ranked
The sun peeked out a few days ago and 40 felt like 70! Pulled the cars out for some air and run time. Still too much crap on the roads to take a drive.
|
02-19-2021, 09:44 AM
|
|
CC Member
|
|
|
Join Date: Jun 2007
Location: Caldwell,
NJ
Cobra Make, Engine: ERA 427, 482ci sideoiler
Posts: 144
|
|
Not Ranked
A warning for those of you who may not be aware and live in locations where ice control solutions are used on roads and driveways. Don't drive your Cobra, classic car, motorcycle, etc. unless you're prepared upon conclusion of the drive to thoroughly clean all traces of said solution from your vehicle, not realistic for your daily driver. Those solutions are extemely corrosive, especially so when left on your vehicle for extended periods.
|
02-19-2021, 03:04 PM
|
|
CC Member
|
|
|
Join Date: Jun 2005
Location: Belleville, 15 miles East of St Louis MO,
IL
Cobra Make, Engine: Classic 427, I purchased it May 2005, the kit was bought in 1991. I'm not sure when it was completed! Installed GMPP Connect & Cruise 376/525 with T-56 S/M 3.55 gears about 2 years ago! 1/4 miles is with old setup!
Posts: 281
|
|
Not Ranked
Glad you got her home safe Larry! After today's drive it should all be down hill!
Now steal some audio off a couple of Cobra videos, slide-in, belt-up, close your eyes and hit play! That dream should hold you until spring! :-)
__________________
Al
I want to do right, Just not right NOW!
|
02-23-2021, 08:49 AM
|
CC Member
|
|
|
Join Date: Dec 2017
Location: Farmersville,
Tx
Cobra Make, Engine: 302. 1992 build
Posts: 247
|
|
Not Ranked
Weather
Bulldog here am just down the road from Mr. Excaliber.we had -4 degree here last week no power for 70 hours ! Crazy Texas power grid insane! But 80 the high today! Go figure. Drove the cobra yesterday was 75 and clear . Hang in guys spring is coming!
|
02-23-2021, 04:30 PM
|
|
CC Member
|
|
|
Join Date: Jun 2005
Location: Belleville, 15 miles East of St Louis MO,
IL
Cobra Make, Engine: Classic 427, I purchased it May 2005, the kit was bought in 1991. I'm not sure when it was completed! Installed GMPP Connect & Cruise 376/525 with T-56 S/M 3.55 gears about 2 years ago! 1/4 miles is with old setup!
Posts: 281
|
|
Not Ranked
WOW, 63* and sunny! Took a short spin in the Cobra and the old truck!
I feel all better now!
__________________
Al
I want to do right, Just not right NOW!
|
02-23-2021, 04:44 PM
|
CC Member
|
|
|
Join Date: Nov 2018
Location: Priceville,
al
Cobra Make, Engine: Unique FIA
Posts: 337
|
|
Not Ranked
63f here in Decatur, Al. today. took my Cobra and the Deuce out for a few minutes.
|
02-23-2021, 06:40 PM
|
CC Member
|
|
|
Join Date: Dec 2017
Location: Farmersville,
Tx
Cobra Make, Engine: 302. 1992 build
Posts: 247
|
|
Not Ranked
Weather
Bulldog here , guys its 80 degrees here today in north Texas last Tuesday it was high around 10 withal wind chill of below 0 .lost power for 70 hours had 6 inches of snow and frozen pipe but no burst pipes. Got lucky on that took cobra out yesterday high was 77 weather is nuts here! Texas power grid is not what it should be ! Hang in spring is near!
|
02-25-2021, 02:39 PM
|
|
CC Member
|
|
|
Join Date: Dec 2017
Cobra Make, Engine: Unique Fresh 427 S/O
Posts: 171
|
|
Not Ranked
Hit 45 today and sunny. I might have taken her out for a ride, but the motor is still at the machine shop. I'm hoping it's done soon so I can start to order parts. Spring is coming and right now I'm Cobraless
|
02-25-2021, 07:35 PM
|
|
Senior Club Cobra Member
|
|
|
Join Date: May 2001
Location: Florence,
AL
Cobra Make, Engine: RCR GT 40 & 1966 Fairlane 390 5 speed
Posts: 4,511
|
|
Not Ranked
took my 66 Fairlane cruising three days this week. 75 degree yesterday. 20 degree last week with ice and snow on the ground. I was stuck at home for six days.
NOT good.
Cruising in the Fairlane makes it better. We have a week of rain forecasted starting tomorrow.
I'll work inside
__________________
''Life's tough.....it's even tougher if you're stupid.'' ~ John Wayne
"Happiness Is A Belt-Fed Weapon"
life's goal should be; "to be smarter than inanimate objects"
|
02-26-2021, 01:03 PM
|
|
CC Member
|
|
|
Join Date: Jun 2005
Location: Belleville, 15 miles East of St Louis MO,
IL
Cobra Make, Engine: Classic 427, I purchased it May 2005, the kit was bought in 1991. I'm not sure when it was completed! Installed GMPP Connect & Cruise 376/525 with T-56 S/M 3.55 gears about 2 years ago! 1/4 miles is with old setup!
Posts: 281
|
|
Not Ranked
Life's goal should be; "to be smarter than inanimate objects"
But so, so many fail!
Some Fairlane details please?
__________________
Al
I want to do right, Just not right NOW!
|
02-27-2021, 05:47 AM
|
|
Senior Club Cobra Member
|
|
|
Join Date: May 2001
Location: Florence,
AL
Cobra Make, Engine: RCR GT 40 & 1966 Fairlane 390 5 speed
Posts: 4,511
|
|
Not Ranked
66 Fairlane Springtime Yellow, 390 with Tremec 3550 5 speed, 3.5 gears in nine inch.
I bought it April 2019 from the third owner. Original a 289 auto eight inch rear end car.
Good clean rust free car. Always local to Moulton, Decatur area. Just a fun cruiser.
I'm building a 427 center oiler for it. Ten months and we are still waiting on parts!!!!!!!!!!!!
I'll try to post pictures
__________________
''Life's tough.....it's even tougher if you're stupid.'' ~ John Wayne
"Happiness Is A Belt-Fed Weapon"
life's goal should be; "to be smarter than inanimate objects"
|
02-27-2021, 07:53 AM
|
|
CC Member
|
|
|
Join Date: Feb 2020
Location: Scottsdale,
AZ
Cobra Make, Engine: BDR Iconic 427 (Dart SHP-Ford 351W)
Posts: 123
|
|
Not Ranked
Quote:
Originally Posted by Larrycobra771
Hi all, this is my very first post ! as of today I am officially a Backdraft cobra owner. ! Waited 5 years to make it possible. It was delivery today in NY, Long Island during the snowstorm by covered carrier. All went well but Carrier could not fit down the road to my home. Had to delivery it in a safe place off the main highway. This attracted all kinds of people stopping to video taping etc. I couldn’t believe that even before this car was uncovered, people gathering around it while it was being lifted out. Kinda cool for me as a new owner. At this time there is almost 2 inches of snow on the ground. My home is about a half mile away. Had the top up, heat on, led lights on, wipers on. Never drove a cobra before this and my heart was pounding.....I can tell u it’s not made for snow. !! Guardsman blue, Wimbledon. 427/480 Iconic. Sitting in my garage with it dreaming for a warmer day. ! Be safe everyone !!
|
Congrats on your BDR, great fun car and you'll love the Iconic 427. Warmer weather will be here before you know it.
This being your first Cobra, be gentle at first. As you know, the car has a lot of power and torque and the back tires can kick out real easy.
Enjoy, send photos and be safe!
Gus
|
02-27-2021, 08:39 AM
|
|
CC Member
|
|
|
Join Date: Jun 2005
Location: Belleville, 15 miles East of St Louis MO,
IL
Cobra Make, Engine: Classic 427, I purchased it May 2005, the kit was bought in 1991. I'm not sure when it was completed! Installed GMPP Connect & Cruise 376/525 with T-56 S/M 3.55 gears about 2 years ago! 1/4 miles is with old setup!
Posts: 281
|
|
Not Ranked
Quote:
Originally Posted by Dwight
66 Fairlane Springtime Yellow, 390 with Tremec 3550 5 speed, 3.5 gears in nine inch.
I bought it April 2019 from the third owner. Original a 289 auto eight inch rear end car.
Good clean rust free car. Always local to Moulton, Decatur area. Just a fun cruiser.
I'm building a 427 center oiler for it. Ten months and we are still waiting on parts!!!!!!!!!!!!
I'll try to post pictures
|
When I was 15-16 they guy next door bought a 67 289 3 spd, also yellow! Boy would he twist it in 2nd gear!
__________________
Al
I want to do right, Just not right NOW!
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -7. The time now is 05:19 PM.
Links monetized by VigLink
|