CRL Seats

dfconsult · #1 (**permalink**) 05-20-2006, 09:40 AM

I seem to have a problem with people fitting into the drivers seat of my Cobra. I have the seat all the way back where the seatback touches the carpeted inclined surface just below the horizontal (package-tray).. There is a few inches to go in the area behind the lower seatback. If I could change the angle of the seatback I could probably get the seat back further..
Is this possible??
Is the seat cushion easily removable?

Thanks
Dave

kidcobra · #2 (**permalink**) 05-20-2006, 10:00 AM

I had the same situation sort of. Mine was the seat seemed to be layed back way to far for my liking. So all I did was shim up the seat using washers. Then I made a bracket that went from side to side on the rear of the seat. I was able to get a lot more leg room and have the seat sit at the angle I wanted. It didnt take to long to do.
Matt