radiator hose part numbers:

[Hray]

I have a 302 ford, using the radiator that CR sent with the kit.
anyone know the hose numbers that I would need for upper and lower.

Thanks bunches.

Ray

[Curt C.]

just take them down to the local part store and look for ones with similar bends.

[Hray]

Hey Curt: thanks for the idea, would be good if I had some to take down. I have been down the road of trial fitting a dozen hoses until I find one that fits, or I can make it fit. I was looking for the easy way out by just getting a part number. With building customs I should know there is no easy way out.

Thanks much Ray

[capteddie]

Originally Posted by Hray

I have a 302 ford, using the radiator that CR sent with the kit.
anyone know the hose numbers that I would need for upper and lower.

Thanks bunches.

Ray

You could always go this route. More $$$ but flexible and cool looking.

http://www.coolflex.com/cfm/welcome.cfm

Ed

[BRSIII]

I also have a 302 in a CR with their supplied radiator. Autozone - top hose: XL 3 (sku-37256 00003) Two bottom hoses with a pipe between: 928 (sku-3256 17263) & 135 (sku - 37256 00135). Sorry can't do better w/part numbers. Saved the bar codes. But, the bottom hoses tend to want to collapse at higher RPM. Didn't find this out till I was curving the dist. I put a couple hose clamps on it, seems to have worked.

[wetdog]

Jegs ? summit make fittings that adapt 1 3/4 hose end to #16 AN they also make a filler neck that is # 16 AN as well I will try to post pics . WD

[Hray]

Thanks folks, this is more than I knew when I started.

Ray