09-19-2008, 01:47 PM
|
|
CC Member
|
|
|
Join Date: May 2001
Location: Irvine, CA.,
CA
Cobra Make, Engine: Classic Roadster 427SC, 351W bored .30, Edelbrock Performer RPM Package, Tremec trans, Currie 9" rear end.
Posts: 50
|
|
Not Ranked
Rear control arm bushings
I am in the process of boxing my rear lower control arms. I thought I would upgrade to energy suspension urethane bushings while everything is apart. I picked up a set of bushings as outlined in prior threads for 79- up mustang (not GT) and they look like they will work except that the inner sleeve is for a 1/2" bolt and my controls arms are using a 9/16 bolt. Can the sleeves be pressed out and swapped. Also, the old ones look like there could be an outer sleeve but it is hard to tell. I can certainly take these back if I am wasting my time and they won't fit.
|
Linear Mode
