Windshiel wiper trans. holes!

Double Venom · #1 (**permalink**) 05-29-2009, 04:15 PM

OK,
I give up, who wanted the schematic where the wiper shafts fit?
I've made a template but forgotten who gets it! ???
DV

MotorcityCobra · #2 (**permalink**) 05-31-2009, 09:53 PM

It was me! I was just starting to check around for other Classics in the area to try to make my own. Thank you in advance.

Sent you a couple emails a while back... you get 'em?

Thanks again,

MC

Double Venom · #3 (**permalink**) 06-01-2009, 04:37 AM

MC-
Dont think so???? v10doublevenom@peoplepc.com .Try sending me your address again & I'll ship it! Remember how to find center of the cowl?
DV

MotorcityCobra · #4 (**permalink**) 06-01-2009, 12:01 PM

Sent you an email.

As I recall you used the installed windshield to find center, then made a mark on the body under the windshield molding. Something like that, anyway.

Thanks.

Double Venom · #5 (**permalink**) 06-01-2009, 03:05 PM

exactly-you can use the two small holes at the bottom of the windshield, find the center of those with the windshield in place-wallllha!
DV

MotorcityCobra · #6 (**permalink**) 06-08-2009, 07:32 AM

DV,

Thanks for the template. Everything seems to make sense. I also used my stud finder to do a quick verification of the 1/8" clearance you were talking about... I see it.

Unfortunately, I blew out my knee yesturday and I'm suppose to be out for 2 weeks, but I don't think these holes will be a problem when I do get to them.

I'll put a little something in the mail for you for your effort and postage (once I'm literally back on my feet). Making a template goes beyond just answering questions on this forum.

Thanks, again,

MC

Double Venom · #7 (**permalink**) 06-08-2009, 08:44 AM

MC,
Please don't embaress me! Just haul you (& the Cobra

) back over some time! Hope your knee is getting better! I did that once-talk about pain~~~~~ewwww!
DV

MotorcityCobra · #8 (**permalink**) 06-11-2009, 11:53 AM

DV,

OK. Thanks again.

MC