Aluminum Body And 4" Tube Frame Chassis For Sale

[rnunn]

English Hand Made Body (Williams & Pritchard Co.) with 4" Tube Frame Chassis (95 % complete). The chassis has not been powder coated or painted. It has been blasted. The remaining parts to be made are the handbrake bracket, the door frame latch brackets, and the door strike brackets. The body was made in England about 20 years ago from an original AC body buck. The body does need some minor work on some of the cab corners because of fitting it to the frame. The remaining body work will cost about $2k to finish. The body is still off the frame as of now because of fabricating parts for the chassis. The hood and trunk are made, but not attached to the frames (frames are complete). The door frames are complete, but I do not have the skins for them. I also have a lot of aluminum interior parts, such as the floor, transmission tunnel, dash panel (gauge holes not cut out), fiberglass spare tire holder, foot boxes, (3) 4'x'8' sheets of .050 aluminum. I do have the front upper and lower a-arms, the rear wishbone lower arms for a CSI rear end, 4 wheel disk brake system (unkown manufacturer). I may have some other parts to go with it. I have pictures I can email to you, I could not download them to the website. This will make a great car for someone to complete. $20k or REASONABLE OFFER. I have a lot more than this tied up in it. What's listed is what is for sale. email me: robbien at jsclark dot com (work email)
melanied at animascorp com (home email)