Club Cobra GasN Exhaust  

Go Back   Club Cobra > For Sale > Cobras For Sale

MMG Superformance
Nevada Classics
Main Menu
Module Jump:
Nevada Classics
Nevada Classics
MMG Superformance
Advertise at CC
Banner Ad Rates
Keith Craft Racing
MMG Superformance
December 2024
S M T W T F S
1 2 3 4 5 6 7
8 9 10 11 12 13 14
15 16 17 18 19 20 21
22 23 24 25 26 27 28
29 30 31        

Kirkham Motorsports

 
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 04-24-2006, 06:46 PM
mts mts is offline
CC Member
Visit my Photo Gallery

 
Join Date: Aug 2005
Location: Lexington, KY, KY
Cobra Make, Engine:
Posts: 5
Not Ranked     
Default Factory Five MK II #5015 for sale

FFR 5015 is recently completed and road tested and now is up for sale to move on to another project. She was built as a street car that could shine at the occassional lapping day.

She has about 500 miles on her including a test and tune lapping day where she did very well. There is over $45k invested in the car, asking $31,900.

The car is registered, plated and titled as a 1965 certified historic vehicle.

PM me with questions, or email to mshepherd@ddfky.com, or phone is 859-425-7637.

Parts list is below.


Engine & Exhaust

-1995 Ford 351 professionally dyno tuned by SR Racing
-rebuilt .030 over
-Eagle rods
-SRP Forged pistons, 10.5:1 compression
-Stock crank, never turned
-Comp Cams Hydraulic roller camshaft .565 intake lift/ .574 exhaust lift, 282* intake/290* exhaust, 112* lobe seperation, RPM range-2500-6500
-Edelbrock Victor Jr. Heads (unported)
-# High-flowing 210cc intake ports and .130" raised 75cc exhaust ports
-2.05"/1.60" valve size
-Edelbrock Victor Jr. Intake
-ARP bolts
-Replica parts waterpump kit
-Mr. Altenator 95 amp alernator w/ regulator wiring kit.
-Holley 670 Street Avenger with electric choke
-MAC shorty headers coated w/black Jet-Hot 2000
-FFR catalytic converters coated w/black Jet-Hot 2000 (extra set of J-pipes too)
-FFR 4x4 side pipes coated w/black Jet-Hot 1300
-Mike Francuck side pipe heat shields coated w/black Jet Hot 1300
-Crane 1.6 roller rockers
-Mallory 4309 return style fuel pressure reulator
-Aeroquip –8AN braided stainless steel hose in engine compartment
-Ron Morris Performance 3/8 inch Nylon fuel line/ fittings from tank to motor.
-New stock 1991 Mustang fuel pump/screen
-1991 Mustang fuel tank
-Black “Cobra” valve covers from Ford Racing
-Cobra 18” black air cleaner from Ford Racing
-Tristate Motorsports aluminum radiator.
-Billet aluminum “T” filler with new radiator cap
-9mm Ford Racing spark Plug wires
-Braided custom Lokar stainless steel dipstick
-New upper and lower radiator hoses.
-Chrome fuel filter.
-Lokar throttle cable
-MSD 6-AL Ignition w/ hidden kill switch and multiple Rev limiter chips
-MSD Billet distributor
-MSD Steel distributor gear for roller cam
-MSD ignition advance kit
-MSD Blaster coil
-Energy suspension poly. Engine and Trans. Mounts
-Extra set of solid engine mounts as well
-Mr. Altenator New Ford Mini-starter
-Dyno’d at 320 rwhp WITH cats

Transmission/Rear-end

-Tremec 3550 5-speed. Proper tremec fluid. 3.27, 1.98, 1.34, 1.00, .68(OD)
-Tristate Motorsports new shortened driveshaft.
-Aluminum clutch quadrant and adjuster
-Steeda adjustable clutch cable
-Steeda Tri-Ax Billet aluminum shifter for Tremec 3550
-SPEC Stage II Clutch (SPEC PN SF482) rated 520 ft/lbs
-Ford MotorSport Aluminum Bellhousing
-Ford MotorSport Billet flywheel
-8.8 ford live axle from 1991 Mustang. All new seals, bearings, brakes, axles, etc
-Ford Motorsport 3.55 gears (new)
-Trick-Flow aluminum diff cover with heat sinks

Wheels/Tires

-Wheel Replicas Mustang Bullet, Black center section. 17 x 9 front, 17x 10.5 rear
-Nitto NT 555R 315/35 drag radials, rear.
-Exclaim UHP 245/45 Z rated, front.
-Track Wheels & tires available but not included in price

Brakes/Steering/Suspension

-Front Brakes – Levy Racing Wilwood 13” vented rotors w/6-piston calipers and speedbleeders(5 lug).
-Rear Brakes – Levy Racing Wilwood 12” rotors w/4-piston calipers, Levy parking brake and speedbleeders (5 lug).
-Wilwood Q compound pads
-Wilwood brake proportioning valve in cockpit
-Lokar parking brake handle and brake lines
-Tristate Motorsports Pre-Bent brake line kit
-Tristate Motorasports Pre-bent Rear brake line kit
-Front Stainless Steel braided brake lines
-8.8 axle rear braided brake lines
-1984 Jeep cherokee Brake Master Cylinder
-New front wheel bearings/seals
-Tubular upper and lower front and rear control arms
-Fortes 18:1 manual rack
-Levy Racing Street bump steer kit
-Breeze lower steering shaft
-Tristates upper steering shaft
-Pro Shock shocks and adjustable height coilovers
-Front/Rear spring rates 450/250
-3-link bundle. Includes 3-link setup, coilovers, tubular rear control arms
-Vintage Performance adjustable front & rear anti-swaybars

Body & Cockpit

-Breeze Street Performer seat mounts
-Street Performer seats with professionally installed seat heaters (driver and passenger)
-Compact Heater from Campbell Cobra products
-It’s a Snap wiring harness
-(2) 12v accessory outlets under dash
-Aluminum gas pedal
-Roush Racing aluminum brake and clutch pedals
-Replicaparts reconditioned pedal box with brake pedal mod for manual brakes
-Replica Parts under dash filler panel
-Optima Red Top battery ULT-9004-003
-Battery cut-off switch in cockpit
-Billet aluminum battery hold down
-Insulation/sound deadner in cockpit and trunk
-Rubber undercoating under fiberglass body and on exposed aluminum
-Thermo-Tec 2000 degree reflective panels in engine bay and footboxes
-Black carpet in trunk
-Autometer 427 Replica guages w/ reverse speedo & oil temp gauge
-Braided oil pressure gauge line Reverse speedo adaptor
-New 60” speedo cable
-APE hardtop with window kit
-14” Leather steering wheel
-(2) Raydot spun aluminum racing mirrors
-dual roll bars professionally powdercoated black
-Russ Thompson rollbar bezels
-hood hinge kit
-Bethania Garage stainless front and rear bumpers w/Finish Line front and rear rubber body gromets
-Breeze radiator cover
-Levy leather door panels
-3M clear bra coating kit


Accessories

-Powered by Ford side emblems
-Cobra Nose and Deck emblems
-Vinyl static cling fender stipe, Red.
-Shelby VIN Plate w/ “FFR5015R” engraved
-Finish Line starter button
Attached Images
  
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 05:20 AM.


Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink