Roll bar?

[Radiodio]

Hello to you all.
I'm new to this site.
I live in Finland. I found myself last summer from German ERA Cobra 427
The identification number # 117

I would now be one question regarding the ERA 427 roll bar design.
I would like to know the pipe diameter and the width of the arc center to center.
Thank you.

[strictlypersonl]

Originally Posted by Radiodio

Hello to you all.
I'm new to this site.
I live in Finland. I found myself last summer from German ERA Cobra 427
The identification number # 117

I would now be one question regarding the ERA 427 roll bar design.
I would like to know the pipe diameter and the width of the arc center to center.
Thank you.

The DOM tubing is 1.5" OD x .120" Wall. It's bent over a 6" radius mandrel, so the finished diameter is about 12.1". (The pipe springs back a bit.)

[Radiodio]

Thank you for your prompt reply.

[DonC]

Hey Bob. Twenty-two minutes to get a reply from you? Must be slowing down in your dotage. We didn't used to have to wait so long for an answer.
DonC

[strictlypersonl]

Purely random... Usually I log on at break time (or whenever I get totally frustrated).