switch bezel tool update

[Bob Perry]

Thanks to all who helped on my first thread. After reading them i had a couple of crown royals and headed for the garage and heres what i came up with. First i got a craftsman 1/4 drive 9/16 deep socket (The 9/16 is the same diameter as the bezel and deep to clear the switch) Then with a sharpie pen i marked were the prongs go . Then off to the bench grinder for a couple of minutes and some final touch up with a flat file.This along with a backing card for protection worked great and all for $3.00 (less the crown) Hope this helps someone....

[REDSC400]

There you go Bob! Nice job.

[Bob Perry]

Hey Art, Hows the weather back there, I grew up in south windsor but moved west a few years ago . Sure do miss it this time a year...... Bob..

[REDSC400]

Hi Bob:
The weather this summer was just perfect. Sufficient rain so things stayed green all summer. Not too hot, mild. Used the air conditioner only about 10 times. So far the fall was very nice. We are starting to get colder now, with some frost on the grass on some mornings. All the leaves are down and blowing around.

On nice days when the temps get to the mid 60's it is perfect Cobra driving weather. The big block is like a heater. However, this is now, for the most part, leather jacket, turtleneck, gloves, cap and earmuff driving weather with the top down.

Its not winter yet and the days still have one more month of getting shorter.... drat.

Today and yesterday, I am out in the heated barn (stove) crawling around under the Cobra (on jackstands), cleaning and changing fluids and inspecting. You know... acting obsessed in the typical manner of those demented.

You can eat off the undercarriage of this baby even after 11 years.

Sickness...... Serious Sickness....



BTW: I do not want to HEAR about your weather....