push rod length - Page 2

RET_COP · #21 (**permalink**) 07-24-2014, 01:28 PM

If you change rockers you'll need to re check your pushrod lengths again, unfortunately there is NO standard geometry. I found it better to have a small width for the witness mark than to have a large wider mark more centered on the valve tip. There is a compromise, you certainly don't want the marks on the extreme outer edges of the valve tip.

crenbbf · #22 (**permalink**) 07-24-2014, 02:43 PM

Quote:

Originally Posted by RET_COP

If you change rockers you'll need to re check your pushrod lengths again, unfortunately there is NO standard geometry. I found it better to have a small width for the witness mark than to have a large wider mark more centered on the valve tip. There is a compromise, you certainly don't want the marks on the extreme outer edges of the valve tip.

Yeah Lou

We managed to get pretty good witness marks pity we were using s**t

cheers



FE Forums sponsored by Keith Craft Inc.