427 SO connecting rods

Bob W · #1 (**permalink**) 03-04-2004, 07:03 PM

In need of connecting rods for a 1966 427 Side Oiler with 428 crank. Only need two, but will consider any and all parts for same. Anybody out there in need of cleaning out there garage of some old or new parts?

FFR428 · #2 (**permalink**) 03-05-2004, 06:58 AM

What kind of rods are you running? The LeMans? I see these on ebay from time to time and not in sets. I have some C7 and C3 if you are not using the LeMans rods. G.

Bob W · #3 (**permalink**) 03-07-2004, 07:02 PM

Thanks for the reply. I am running the lemans rods, lucking to find (2) which is what I needed. However the balancing will be the issue. May have access to 5 more, need to flux and confirm the condition of them. I will check E-bay, but a little leary of some of the stuff sold there.
Thanks again.

FFR428 · #4 (**permalink**) 03-08-2004, 02:44 PM

Try the guys over at www.fordfe.com There is always someone with a few there. Ebay scares me too. While there are some good deals you need to wade through the crap. G.

Cracker · #5 (**permalink**) 03-08-2004, 03:45 PM

I have a complete set out of my '66 side-oiler but I won't break them up.

RiverRacer · #6 (**permalink**) 03-14-2004, 11:20 PM

I have 23 good spares. If you give me a weight to shoot for, I can get you a couple that are close(as close as possible) so you're trimming will be as little as possible on your balance. www.dscmotorsport.com



FE Forums sponsored by Keith Craft Inc.