Performance Engineering (Donnie Anderson) San Antonio

Igofastr · #1 (**permalink**) 02-23-2006, 07:44 AM

Does anybody out there have any experience with Performance Engineering in San Antonio? I understand that the owner, Donnie Anderson is a little tight lipped. What is his rep as far as FE motors go?

Thanks, Ron R

Power Surge · #2 (**permalink**) 02-23-2006, 08:37 AM

Hey Ron, you buy another Kirkham?

(look at your profile

)

Igofastr · #3 (**permalink**) 02-23-2006, 09:25 AM

Thanks Sal, Just made the correction. Wouldn't want to tick off the real owner of KMP257.

Got your CSX on the road yet? I'd like to think that you'll beat me, as you've been waiting a lot longer than I have.

I'm in the serious engine hunting mode now. Got my tranny in the mail (I hope), the exhaust is rusting on my garage floor, and lots of bits and pieces are scattered throughout my office. I've got to pick up some batteries, but thats about it.

Ron

Power Surge · #4 (**permalink**) 02-23-2006, 09:28 AM

Nope, not on the road yet, but maybe this summer. Since my car was already a running car, it shouldn't take much. But I'm redoing a lot on the car, and all the detail work is time consuming and extensive, with tracking down original parts, nuts, bolts, wiring etc. But I should have the engine actually in the car withing a month or so.

Igofastr · #5 (**permalink**) 02-23-2006, 02:18 PM

Come on all you Texans, someone must know this guy?



FE Forums sponsored by Keith Craft Inc.