ignition wire looms for lemans covers

[jeffcmotorsport]

i am looking for the correct wire looms to use on my 427 fe, the covers i have are ford cast alum and say cobra/le mans on them, on the center of the covers is a stand to hold a wire loom, where can i purchase these looms to route my wires up and over on my csx4000 #15, thanks, jeff

[351-EM]

Jeff,

I bought a set of these looms when I purchased other items from Finishline (www.cobraaccessories.com) they were reasonable, plus I needed other stuff from Enzo (The Owner) anyway. Lots of luck


Chris

[lineslinger]

I bought a set of two, three and four hole guides and mocked up my own clips to fit the Le Mans covers. The guides can move/swivel freely on the "clip" while still being held firmly in place.

[ceslaw]

Finish Line sells the exact part, called a "Wire Separator for Valve Covers." Cost is $6.00 each in my catalog. Snaps right in place on the Cobra Lemans case valve cover. Quick, easy and right.

[ceslaw]

[IMG][/IMG]Finish Line sells the exact part, called a "Wire Separator for Valve Covers." Cost is $6.00 each in my catalog. Snaps right in place on the Cobra Lemans case valve cover. Quick, easy and right.

[Rick Parker]

Any vendor for 60's Mustang stuff sells these. Same as on 289. Standard fare for most all 60's Ford V8's. The current 8mm Helicore MSD type wires will fit in the "old" 7mm clips. I also think there are some 8mm clips too, but may not be readily available.

[RedCSX1]

I picked up several of them up at a salvage yard for a few dollars.

[Cashburn]

On the bigger wire sets (9mm) some careful drilling and a few machine screws and you can mount the Ford Racing wire separator to the cover: