01-10-2011, 04:19 PM
|
 |
CC Member
|
|
|
Join Date: Feb 2006
Location: Reno,
NV
Cobra Make, Engine:
Posts: 46
|
|
Not Ranked
HeadER gaskets... not headgaskets
Maxx.. in complete agreement on your HAND BUILT cars...
Assuming we're even speaking the same language.. On the HEADER gaskets, not head gaskets. YES.. Machined surface on the header. As a matter of fact, on the 402 headers (AFR port) from SPF, they were not coming in strait and I was having them milled myself, at no cost to the customer (machined surface). We've all heard of thermal expansion.. well most of us anyways. I am not new to this subject, and there is no need for an exhaust gasket. A thin coat of high temp Permatex does the trick, I know this from experience. In my personal opinion, having the gasket... heat expansion, cooling contraction, and someone continually cranking down on header bolts to keep them tight.. the flange ends up becoming warped. Just my opinion...
Its no wonder I don't frequent these sites often......
|
Linear Mode
