05-17-2013, 11:22 AM
|
CC Member
|
|
|
Join Date: Jan 2008
Location: Lodi,
CA
Cobra Make, Engine: ERA #773, 482 stroker, cross ram stack injection
Posts: 95
|
|
Not Ranked
Bob;
The car still is not completed. I should get the motor back from Autotrend EFI next week. Dave did the preliminary wiring and test fired the motor. I will install the motor in the car and get it back to him for completion of the wiring. Then the car comes back to me for finish and trim. Hope to have it on the road in six months... Just in time for Christmas!
It's been a long process. The motor spec. was a lot more complicated than I had imagined. (fabricated cross ram with 8 throttle bodies, direct port injection, distributorless ignition, remote electric water pump... ) But if I were to do it again, I would not change much of anything...
Dave Ehrlich has been great to work with, and so has Neil Ruegsegger, the engine builder. The guys at ERA are a pleasure to work with, too.
I would like to attend a breakfast in Sacramento in the near future.
__________________
Drink no wine before its time
|