pollished holley 750 will sell or trade

[big_rob]

THIS IS A NEW HOLLEY HIGH PERFORMANCE POLISHED 750 CFM FOUR BARREL CARB THAT WAS USED ON A MOTOR DISPLAY ONLY. IF YOU ARE LOOKING MORE HORSEPOWER OUT OF YOUR STREET CRUISER OR FASTER TIMES AT THE DRAGSTRIP, YOU NEED THIS CARB. THE VACUUM SECONDARIES AND MANUAL CHOKE MAKES THESE CARBS WORK GREAT ON NEARLY ANY SIZE ENGINE BECAUSE THEY ALLOW YOUR ENGINE TO ONLY GET THE GAS IT ACTUALLY NEEDS WHEN IT NEEDS IT AND CAN BE ADJUSTED TO FIT YOUR ENGINES NEEDS. AS OPPOSED TO A DOUBLE PUMPER THAT DUMPS TOO MUCH FUEL ALL AT ONCE AND ACTUALLY SLOWS YOU DOWN TAKING OFF. WE CAREFULLY INSPECT,TIGTHEN ALL SCREWS AND INSTALL ALL CARBS ON A ENGINE DYNO TEST STAND AND RUN TEST AND ADJUST THE PUMP,AIR AND FLOAT LEVEL. SO WHEN YOU GET IT JUST BOLT IT ON AND GO RACING STREET OR STRIP. THE BRIGHT ZINK WOULD LOOK GREAT ON A SHOW CAR, THE LIST # IS 3310. YOU CAN SAVE A LOT OF MONEY OFF RETAIL WITH THIS CARB. WILL GIVE YOU MORE POWER AND BETTER GAS MILEAGE. BUYER PAYS $15.00 SHIPPING IN THE LOWER 48 STATES. ANYWHERE OUTSIDE THE LOWER 48 STATES WILL HAVE TO BE ADJUSTED TO WHERE YOU LIVE. CANADA AND PUERTO RICO ARE AROUND $29.00 MOST OVERSEAS SHIPMENTS AVERAGE AROUND $35.00 FOR SURFACE MAIL. I ACCEPT CREDIT CARDS THROUGH PAYPAL

$200.00[b]

[big_rob]

pics of the carb can be found at this thread in the parts wanted section...

looking for a 600cfm carb for stock 302

[Unique580hp]

Hello,

I have a Holley 600 that came off of my 357 Windsor that I am not using. Would you want to trade?

[big_rob]

could you tell me about the condition and possibly send some pictures of your holley 600