Shorty headers for Windsor 351

CbyM · #1 (**permalink**) 10-20-2004, 06:05 AM

Need a stock (or custom) header to fit between a Backdraft firewall and Roush 392AL (Windsor 351).
Ideally, the collector would point straight down to the ground below the 3rd spark plug back on each side, and width will not come too far off the block (less than 3.75"), yet provide for spark plug accessibility.
Time is of the essence, as everything else is done to start the engine.
Note that the Backdraft Cobra is being finished off in the Miami area.
Thanks --

Phil Bohm · #2 (**permalink**) 01-28-2005, 08:43 AM

I also need a set of headers for a 351w engine. If you find a supplier, I would appreciate it if you would let me know. Thanks.

Phil

Tim Brewer · #3 (**permalink**) 01-28-2005, 09:18 AM

Phil,
Headers are car specific,( from your cobra mfg.) or custom made on your car at a race car fab shop or the like.
Tim

Phil Bohm · #4 (**permalink**) 01-28-2005, 10:00 AM

thanks for the info. I've emailed Classic Roadsters on the subject. The company has changed hands but maybe they have some old inventory.

fxbill · #5 (**permalink**) 02-13-2005, 01:55 AM

Hi Phil,
I'm sure by now you know that Don Scott, the new owner of Classic Roadsters, is right here on this forum in the "Classic Roadsters II" section. Might be easier to just contact him here!