Need help with Throttle linkage

ROMANBUILT · #1 (**permalink**) 07-29-2005, 10:31 PM

Guys,

HAving a real hard time with the linkage supplied by SVC. Just cannot getting it to wide open throttle with the supplies I have. Could anyone email or post pictures of thier linkage and how it is set up so that I can see how others have rigged it to work. It feels like I have tried everything, but there must be a way. Maybe I have the short an long legs reversed. I just do not know.

Help.

Romanbuilt

trctrdrvr · #2 (**permalink**) 08-29-2006, 03:40 PM

Send me your email address and I will send you pics of my linkage, I used some of SV stuff and fabricated the rest.

Mike
mpbp43@sbcglobal.net

elgecko · #3 (**permalink**) 08-29-2006, 06:43 PM

Mike
I sure would like to see pics of your setup also.
I'll sent you an email.
Thanks
Dave

Dirty Harry · #4 (**permalink**) 10-20-2006, 08:12 PM

I also had to do some fabricating on my linkage. The pedal assembly was OK and the linkage between the carburetor and firewall was OK, but I had to make a piece to connect the pedal linkage to the linkage on the firewall. It turned out fine and gives me some adjustability of the pedal height.

Clois Harlan · #5 (**permalink**) 10-20-2006, 09:01 PM

Romanbuilt,

My guess your levers are slipping on the rod that runs parallel to your fire wall. I would suggest that either you spot weld them in place or drill a small hole thru the lever and rod and use a roll pin once you get everything in the position you want.

Clois