Clutch slave cylinder mounting bracket

SVMCOBRA · #1 (**permalink**) 08-13-2001, 07:45 PM

Hello fellow club members

. I am using a FMS Tremec and FMS bellhousing behind my 351W. This setup requires a pusher slave cylinder. I have a slave cylinder but am looking for a mounting bracket. Does anyone know where I can purchase one??
Thanks in advance, Ray

Cobra20646 · #2 (**permalink**) 08-14-2001, 10:50 AM

Ray,
Some, if not all, kit manufactures have some kind of brackets available, but may or may not support your choice of clutch fork/bell housing/slave cylinder type.
You may be on your own to fabricate what you need. To disengage your clutch, what direction does the clutch fork move; towards the front of the car or to the rear? I may have some pixs put away somewhere that may help you create what you need. I can e-mail rather than post here. Let me know
- Jim -

smokintires · #3 (**permalink**) 08-14-2001, 10:07 PM

Ray:
I ordered a clutch slave conversion kit from John's Mustang and Classics, located in CA. I thought it was a little pricey, but it is a very nice kit, which will attach to a 3550/TKO Tremec using existing holes. I haven't tried it yet, but bolts up nicely. Let me know if you can't find a phone # and I can dig it up for you.

Mike