11-04-2003, 01:13 PM
|
 |
CC Member
|
|
|
Join Date: Dec 2000
Location: Los Angeles,
CA
Cobra Make, Engine: E.R.A. FIA #2088 1964 289 w/Webers
Posts: 2,151
|
|
Not Ranked
Body work side vent holes.....
I'm to the point of working on the body where the side vents are. Does anyone have a good closeup pic of this area? Most importantly= the holes are cut as if they used some type of 90 deg saw so the cut is clean & square. I'm curious if this edge should be rounded? or should I just clean it up & paint?
__________________
Hyde D. Baker
|
Threaded Mode
