02-23-2003, 07:24 PM
|
 |
CC Member
|
|
|
Join Date: Dec 2002
Location: Kennett Square, PA, USA,
Posts: 201
|
|
Not Ranked
GT40-X Heads
After inspecting Mine that I removed to change Gaskets. I made this observation!
Mine are the worst CNC Machined Heads I have ever seen. The edges of the Combustion Chambers were sharp and uneven.
I also actually had to take a Rat Tail File and remove part of the Aluminum Casting from the Exhaust Ports that were blocked.
The beauty of CNC Maching is the quality of the finished Product.
If I were seriously interested in getting the maximum performance I could from this Engine, then these Heads should have been sent out for work. Given a choice, I would chose a different Manufacturer.
If this is Fords answer to Fast Burns, then they need to try alot harder. Theirs are not even close!
|
Linear Mode
