07-28-2003, 07:11 PM
|
|
CC Member
|
|
|
Join Date: Jul 2003
Location: Cleveland,
OH
Cobra Make, Engine: SPF1670 Stroked Little Windsor - Runs OK.
Posts: 1,244
|
|
Not Ranked
cut the neck off, get a thermostat housing, figure where you want the neck on the tank, take it to a radiator shop, have them braise the new neck in the bottom where you want it and close off the old hole. Run a piece of rubber hose from the neck of the tank to the thermostat housing (90 degree works well). Wash, rinse, repeat. I did this - not the most fun I've had, but it worked. Took a P.O.S. FE tank from a 390 , had to do all kinds of body work on it, etc...but it looked perfect. For about a week, then we got air in our system and the thing came under serious pressure - more than the cap could vent, and we blew the tank up. It didn't separate, but it did round out real nice.
__________________
J.P.
Ohio Cobra Club
Token Gashole
|
Expansion tank
Linear Mode
