intake openings at front sizes

[maxum_101]

hi all looking for some help on finding out what size the 2 openings are on the intake manifold at the front of my ford mosport 351w crate engine is, its a vic jr single plane intake, i have the factory superformance water temp sender on the left side ( looking at the engine from the front) and need to put it on the other side of the intake, so i need to know the sizes to plug the left one and need to buy the propper fitting to put the sending unit on the other side. anyone know the threads and sizes on this

[maxum_101]

anyone? someone has to know this

[sllib]

I went out and looked at a bare Vic Jr. I had in the garage, but I had nothing to measure it with! I can tell you it's the same thread size as a standard heater hose barb (the one you thread into the water pump). I would go to the Edelbrock web site and look at the engineering drawings for that intake.
Bill Stradtner

[DAVID GAGNARD]

Not sure the exact size, both holes are the same size on my Victor Jr. intake.... for a "standard" mechanical gauge sender I had to get a brass adapter to size the hole smaller for the sending unit to screw into.....

David