Sheared off bleed screw refreshing fluid

[tortuga]

Last screw of last caliper (inner drivers front) twisted right in half when going to loosen the inner 1/4 bleed screw (housing sheared in half) seeing as i was one man pressure bleeding it made quite the mess...

On searching the inter-web i came across some photos of bleed assemblies broken the same way...

Does anyone have a source for a replacement bleed assy (at least the outside)?

Thanks

SPO 1764 2003, four piston dual bleed calipers x 4

[DWRAT]

Deleted

[DWRAT]

This looks real close. Wilwood High-Performance Disc Brakes - Flexline No: 220-0627

[NRP/MN]

You are looking for a 1/8" NPT brass bleeder assembly. Should be available in Weatherhead or Dorman product line, at your local parts store under $5.00. Wilwood also sells this as a repair part.

[DanEC]

You might want to replace it with Dorman speed bleeders with thread sealant and an internal spring loaded valve. They make brake bleeding easier - especially if doing it yourself alone. I found them on the Dorman rack at Pep Boys so most similar auto stores may have them.

[tortuga]

For everyone's info: Summit has them, but prior to install you need to run a 1/8" NPT tap into the hole. The broken piece was easily easy-outed...

Summit part no. 002-0627:
http://www.summitracing.com/parts/wil-220-0627
$10.13 for four.

[trularin]

Pegasus racing???


I get a lot of stuff from these guys - becasuse they have it.

Tru