Windwings for a CMC

Marc · #1 (**permalink**) 11-01-2002, 12:12 PM

Just bought a CMC/Street Beast Cobra 427. The windshield is a domestic model and the Windwings do not fit. The A Piller is on an angle and the windwing blocks are drilled straight. Don't know what to do...Marc

B L & sons · #2 (**permalink**) 11-01-2002, 01:16 PM

Marc
Welcome to the club.
I also have a CMC.There are 30 or so members here with CMC's.
I got my windwings with my kit but am not that far in my build so I may have the same problem.Go to the members list look up kountzecobra he may be able to help you as well as others that have built theres,if not give a call to Tom Beroth 336-922-3018.
Have you checked with finish line? there is a link to there web on the home page or call them 888-436-9113. Good people to work with.
Hope this will help
Bill

B L & sons · #3 (**permalink**) 11-01-2002, 01:25 PM

Don't see the link.must have seen it some where
Finish Line
http://www.cobraaccessories.com
Bill

kountzecobra · #4 (**permalink**) 11-01-2002, 01:59 PM

Mine didn't fit either. I just drilled and tapped new holes in the windshield uprights- 15 minute job.

Roscoe · #5 (**permalink**) 11-03-2002, 07:43 AM

I have an English type windscreen but drilled and tapped it anyway because I did not like the mounting the way it was. Seemed too weak.

Roscoe

racer24 · #6 (**permalink**) 11-03-2002, 08:55 AM

Marc

Check your e-mail , I have CMC and and cobra can have a problem with windwings. Roscoe is righ on ,I sent you step by step on how to make it look good

Good luck

Rich