02-01-2005, 09:12 PM
|
 |
CC Member
|
|
|
Join Date: Jul 2004
Location: Alpharetta,
GA
Cobra Make, Engine: ERA #414 427 s/o w. Shelby Aluminum heads, Edelbrock Performer RPM Intake, Mighty Demon 750, Tremec TKO 600
Posts: 714
|
|
Not Ranked
Performance measuring gauges
I've just installed a Dynorad "On-board dynamometer" in my car. This after trying one of the low end G-Techs (the old, cheap model vs the new $300 models). Haven't actually run the car yet but figured I'd get a post up to see what experiences others have had with these gizmos. The interesting thing with the Dynorad is that it has a rpm sensor that attaches to the drive shaft at the transmission yoke. My intent is to have somethng in the car that I can use to measure tweaks and changes instead of schleping out to the dyno place with my $100 bill in hand. What experiences have others had with these things and has anyone got a Dynorad?
Thanks!
Scott
|
Linear Mode
