Jag IRS pics needed

ZOERA-SC7XX · #1 (**permalink**) 10-03-2007, 03:50 PM

I'm putting together my ERA based Jag rear and I HAVE a manual (Haynes), but the pics of the spacers, seals and washers are inferior. Does anyone have any pics detailing these items on the hub carrier (lower) mounting pins and the lower a-arm mounting pins coming off the housing. I have all new bearings and seals. Just need a couple of detailed pics up close to complete my unit. Thanks.

Tom Wells · #2 (**permalink**) 10-03-2007, 06:43 PM

ZOERA-SC7XX,

Is this what you're asking about?

http://www.cwiinc.com/jagirsparts.htm

Tom

ZOERA-SC7XX · #3 (**permalink**) 10-04-2007, 04:56 PM

Yes. I actually found the same blow-up on another site. Thanks.

CHANMADD · #4 (**permalink**) 10-04-2007, 05:31 PM

Grease those seals and washers before you put them together and then hold them together with grease to aid the assembly.The nipples will not get the grease evenly distributed on their own.I have seen many of those seals come out all pinched and broken from poor assembly in the first place.

strictlypersonl · #5 (**permalink**) 10-05-2007, 04:50 AM

There are lots of hints and parts blowups available from ERA on This Page.

E-mail me if you don't have the "special" link to our full manuals where there is also a scan of the Jag factory manual's relevant pages.

ZOERA-SC7XX · #6 (**permalink**) 10-06-2007, 09:38 AM

Thanks Bob. No, I don't have the 'link'.