Hydraulic brake light switch

[cdnus]

I had my Hobbs brake switch blow a seal & leak fluid under pressure all over my left foot. Thanks for dual master cylinders, still had front brakes so I could drive it home, although somewhat carefully.
The only replacement switch I could locate in a hurry requires 60lbs.pressure to activate.
I would like to find one that comes in @ 2-3lbs & has a 1/8 npt. fitting, normally open, 2- wire connection.
What is everyone else using.

Thanks in advance for any help

Craig

[427sharpe]

I don't have the number handy; but the application is 1965 Mustang. 1/8" NPT & 2 bullet type connectors. Very low pressure required.