SPF Shifter and TKO 600

MCOULTER · #1 (**permalink**) 09-07-2006, 10:13 AM

The holes in my original style shifter does not match up with the holes in the TKO shifter stem. Anyone else have this problem?

xlr8or · #2 (**permalink**) 09-07-2006, 02:03 PM

What trans were you running before?
I have swapped a 3550 for a TKO600 and it was a direct fit on the shifter handle.

sllib · #3 (**permalink**) 09-07-2006, 02:32 PM

I bought a Steeda shifter for a TKO but the holes were too small for my T-600. I just opened the holes up a little with a drill and it slides right on. As long as you're not constantly bangin' your shifts I don't see where it hurts anything.
Bill Stradtner

Jimi G · #4 (**permalink**) 09-07-2006, 04:01 PM

That is what I would recommend also, you can use a die grinder and open up your holes enough to fit the pattern of the TKO shifter. Try and not open them up too much, or your shifter could move a little.

MFE III · #5 (**permalink**) 09-07-2006, 05:36 PM

I had the same problem. I just had to drill out the holes on my shifter to match the size on my TKO 600. Easy job on a drill press!