Anyone know where to get 110 Idle Jet Holders?

[rokndad]

I seem to be striking out on finding a reasonably priced set of either 100 or 110 Idle Jet Holders for my 48 IDA's. I've found them, but don't want to pay $15.25 each. I could solder my current 120's up and I have the drills to make the smaller holes, but I'd rather have a spare set for "tuning" anyway.

I'll buy used ones if someone out there is done with them. Thanks.

Tom

[Hans-Olof Blom]

Try a mail to:

dual-barrel@italian-carburetors.info

it is an Italian company that used to sell Weber jets on ebay.

I have bought some from them without any problems.

I think I payed just over $2.00 each.

[Tom Kirkham]

Some more places to look:

http://www.cbperformance.com/catalog.asp?ProductID=1162

http://www.jaycee-ent.com/carburatorparts.html

http://www.geneberg.com/cat.php?cPath=269_2853

[rokndad]

Thanks Thomas, and Rick Lake for the PM. Left messages for Ace and a couple others. CB Perf doesn't carry them and Gene Berg wants $30.06 each!! Ouch. I have found 120's locally for $12.26 and may just have to bite the bullet and solder them up and drill back out to 110.

Hans, have sent a message to dual-barrels. Thanks for the tip.

[RodKnock]

Originally Posted by rokndad

Thanks Thomas, and Rick Lake for the PM. Left messages for Ace and a couple others. CB Perf doesn't carry them and Gene Berg wants $30.06 each!! Ouch. I have found 120's locally for $12.26 and may just have to bite the bullet and solder them up and drill back out to 110.

Hans, have sent a message to dual-barrels. Thanks for the tip.

Time to put that sidewinder intake and carb back on 4758. "That's all I have to say about that."

Take it easy. I'm just kidding around.

[rokndad]

Originally Posted by RodKnock

Time to put that sidewinder intake and carb back on 4758. "That's all I have to say about that."

Take it easy. I'm just kidding around.

You know, Momma always said that "Webers are like a box of chocolate. You never know what you're going to get".

[4RE KLR]

When I got mine from Inglese they had been soldered (sp) and drilled. They did not work worth a damn.

Matt Tice gave me a set and even helped me put them in. After Enzo, told me how to tune it (over the phone, mind you) it ran like a scalded ape.

Thanks Matt
Thanks Enzo

Point is:
It pays to just get the right stuff to begin with.

[Flat-Tyler]

Ive used cbperformance that Tom linked above. Great service.

[Eljaro]

try here
http://www.dellorto.co.uk/merchandis...rtsectionID=58

[Gun Doc]

I got some .80s I believe from JayCee’s at about half the price everyone else wanted. They are easy enough to drill out with a small bit and pin vise.

Gun Doc