this is my first post. i'm getting real close to completion on my car. i thought i'd introduce my project to the club membership for your thoughts and comments. i grew up in the sixties and have always wanted a snake. had a hemi roadrunner and 442 but i was always a shelby lover. here's my build sheet:
9'' ford rear end with strange 35 spline comp axles
3:55 center locker
powder coated housing
fully adjustable anti roll bar
fully adjustable triangulated four link
fully adjustable upper and lower control arms
wish bone
pneumatic coil overs with cockpit adjuster
4340 chrome moly drive shaft
powder coated frame
c6 powder coated housing
2800 pro torque convertor
351w:
dart heads
roller rockers
comp cam
manley forged rods
je pistons plasma moly rings
svo crank
msd billet dist.
msd ignition, blaster coil
edelbrock intake
edelbrock 750 cfm
ceramic coated headers and side pipes
edelbrock water pump
ho
oil pump
engine dyno'd 462 shaft hp expecting 400+ at the wheels
wilwood 13" at the corners
strange master cylinder
strange proportioning valve under the dash
patriot red pearl with diamond pearl stripes electrical system next!
new street beasts cobra about done
Linear Mode
