Club Cobra Gas-N Exhaust  

Go Back   Club Cobra > Club Forums > Windy City Cobra Club

Keith Craft Racing
Nevada Classics
MMG Superformance
Main Menu
Module Jump:
Nevada Classics
Nevada Classics
MMG Superformance
Keith Craft Racing
Advertise at CC
Banner Ad Rates
MMG Superformance
MMG Superformance
Keith Craft Racing
MMG Superformance
November 2024
S M T W T F S
          1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30

Kirkham Motorsports

Reply
 
LinkBack Thread Tools Display Modes
  #21 (permalink)  
Old 12-14-2003, 01:45 AM
CC Member
Visit my Photo Gallery

 
Join Date: Mar 2000
Location: Virginia, USA, VA
Cobra Make, Engine: Genuine original Unique MotorCars 427 S/C, with a Genuine original Ford 427 Side-oiler.
Posts: 312
Send a message via Yahoo to Cobranut
Not Ranked     
Default 11.89

Made 3 passes at VMP. Concrete starting pad worn smooth, traction sucked.
First time for me on a dragstrip in 20 years!

First pass was 11.89 at 116, left just above idle, granny shifted, pedaled it thru 1'st and 2'nd, got on it in third, then missed the 3-4 shift. Not a good pass at all.

Changed lanes and made two more passes, but traction even worse. Both in low 12's. Then lost the clutch slave cylinder and went home.

One day I'll give it another try. I'm still curious.
I'd be willing to bet she'd run 10's with slicks, but I'm not into drag racing enough to buy a set.

Later,
__________________
David
Reply With Quote
  #22 (permalink)  
Old 12-14-2003, 10:48 AM
Bannon's Avatar
CC Member
Visit my Photo Gallery

 
Join Date: Feb 2000
Location: Montpelier, VA
Cobra Make, Engine: Former Owner of both Superformance #2666 Roush 427IR and Superformance #1601 Ford Crate 460CI - 486 HP 510 ft\lbs TQ
Posts: 347
Not Ranked     
Default

Sniff, Sniff... Well before I sold my car. I clicked off several 11.94's at 118. Superformance w/ 486 hp Ford Crate Motor. 3.55 Gears. 275/60/15 Yokohama Avids got great traction. Although I had to baby it a bit at the launch , I was running 60 ft times in the 1.6 second range. Ate a Viper along the way

JB
__________________
GUMBALL!
Reply With Quote
  #23 (permalink)  
Old 12-14-2003, 11:27 AM
MJN MJN is offline
CC Member
Visit my Photo Gallery

 
Join Date: Oct 2002
Location: Yardley, PA
Cobra Make, Engine: FFR2100X (Mk1) - Whipple Blown 331
Posts: 128
Not Ranked     
Default

I am running 285-40-17's on 17x 9.5 inch wheels on the back. I was getting consistent 1.7 second 60 foot times on the 11.8 runs. The car hooked extremely well leaving just off idle and rolling into the throttle. The trick with street tires is not to 'shock' the tire by dumping the clutch at higher rpms. The soft side wall on a slick is designed to cushion the shock but street tires will just break loose. I also had to soften the shift from 1st to 2nd as if I shifted hard it would spin and kick the rear end sideways. I still need more practice and to play with tire pressure a little to get the most out my combination.
__________________
Mike
Reply With Quote
  #24 (permalink)  
Old 01-04-2004, 12:00 PM
colin mullaney's Avatar
CC Member
Visit my Photo Gallery

 
Join Date: Jan 2001
Location: Red Deer, Ab. Canada, Ab
Cobra Make, Engine: Guyon, big block Chevrolet
Posts: 263
Not Ranked     
Default 8.34 @ 160

My car is street legal right down to the tires. I use Mickey Thompson ET street's. They have been fine so far. Launch at 5,500 rpm, 1.25 60's with one stage of nitrous going. Those times were with my old 460. I haven't had a full pass with both stages of nitrous going yet, but this 598 is 7 tenths quicker than the old one straight up. I can't wait till spring.

Colin
Reply With Quote
  #25 (permalink)  
Old 01-04-2004, 05:22 PM
CC Member
Visit my Photo Gallery

 
Join Date: Dec 2001
Location: Fayetteville, GA,
Posts: 300
Not Ranked     
Default Just a 6 but

Some pretty amazing times on this thread.

My contribution was at 2003 Run & Gun.

10.71 @ 123.8

Courtesy of a Buick V6, normally aspirated, No Nitrous, Mickey Thompson ET Streets, Tremec 5 speed, 9" Ford rear.

Car weighs 2500 with me in it. 274 cubic inches.

There is still more in there I just need to find it
__________________
Bob
Johnex Cobra, Buick V6

Last edited by justa6; 01-04-2004 at 05:25 PM..
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 02:33 PM.


Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink