n6opv
Thu January 22, 2009 11:23pm
|
Arntz tranny tunnel
Shown here is the removable section of the tranny tunnel. With the big engine setback in all the Arntz / Butler cars, you can remove the transmission while seated if you desire. Only a few very late Butlers had this and all Arntz Type 4 cars. I have no idea what the many cutouts are for  Also shown are the two triangulation tubes that connect the center of the cowl hoop to the 2 main frame rails for increased rigidity. The 3rd leg of the roll bar (not shown) also attaches to the same point on the passenger side frame rail. This is Arntz Type 4 only as well.
|
|
RJCCOBRA
Thu January 29, 2009 3:22pm
|
Shell Valley build
Passenger side door latch assembly is installed. We had to cut and reglass a portion of the fender well to get clearance for the striker plate.
|
|
Clois Harlan
Mon March 9, 2009 6:32pm
|
Full shot of HCS Coupe
I know the picture is dark but I forgot to allow my flash on this shot but you can see how well the body has came out of the mold.
|
|
PHM
Fri June 19, 2009 6:21am
Rating: 10
|
Mike's Cobra
Custom Air Cleaner that I Machined from Billet as well as wingnuts and oil breathers
|
|
PHM
Fri June 19, 2009 6:21am
Rating: 10
|
Mike's Cobra
Custom Air Cleaner that I Machined from Billet as well as wingnuts and oil breathers
|
|
PHM
Fri June 19, 2009 6:21am
Rating: 10
|
Mike's Cobra
Custom Air Cleaner that I Machined from Billet as well as wingnuts and oil breathers
|
|
PHM
Fri June 19, 2009 6:21am
Rating: 10
|
Mike's Cobra
Custom Air Cleaner that I Machined from Billet as well as wingnuts and oil breathers
|
|
LREYBURN
Wed October 28, 2009 9:48am
|
|
LREYBURN
Wed October 28, 2009 9:48am
|
|
Mark IV
Sun November 8, 2009 12:52pm
Rating: 10
|
The very small wheels don't handle so well.....
|
|
cobramatt
Fri November 13, 2009 9:13am
Rating: 1
|
Quite comfortable and safe as well
|
|
cobramatt
Fri November 13, 2009 9:13am
|
Full frame built under car (no more unibody) as well as two torque boxes
|
|
Z-linkCobra
Mon April 26, 2010 2:36pm
|
Radiator mounted too!!
Got that done this weekend too. Well it was done but after I got the hood done and had a good freind come over and take a look...I decided to move it a little...Thanks for the input Russ.
|
|
lal Naja
Wed June 2, 2010 9:53pm
|
Setting up the bell housing
This is as close as I can get it. Well within mfg's. specs.
|
|
Z-linkCobra
Tue November 2, 2010 7:27am
|
Fan shroud
Got my fan shroud bent up and installed yesterday as well. No gotta close in the sides and finish it out.
|
|
