Hawkeye
Tue August 18, 2009 9:48pm
Rating: 10
|
Completed Interior
Completed Interior
|
|
cobrasnake
Tue August 25, 2009 9:44pm
Rating: 10
|
Club Auto Sport
Completed Porsches on the racks
|
|
fkemmerer
Thu October 8, 2009 10:31pm
|
Oil Thermostat - Drivers Side 1
Completed installation of a Canton Oil Thermostat on an ERA 427SC showing lines and mounting location.
|
|
fkemmerer
Thu October 8, 2009 10:31pm
Rating: 10
|
Oil Thermostat - Drivers Side 2
Completed installation of a Canton Oil Thermostat on an ERA 427SC. Note that thermostat and plumbing is not very visible to someone looking at the car from a normal angle.
|
|
fkemmerer
Thu October 8, 2009 10:31pm
|
Oil Thermostat - Top down under the hood
Completed installation of a Canton Oil Thermostat on an ERA 427SC showing lines and mounting location.
|
|
traveler
Sun February 28, 2010 12:09am
|
just about completed
interior
|
|
hogster
Sun May 2, 2010 9:43pm
|
Sidepipes 1
Stainless flanges completed ready for welding
|
|
Wbulk
Mon July 5, 2010 8:47pm
Rating: 10
|
B and B Dash
Completed Dash
|
|
Wbulk
Fri July 16, 2010 1:32pm
Rating: 10
|
Rear Bumper Modification
Completed modication with the welded on bracket on the end of the tubes cut off and bolts going through to the frame bracket.
|
|
pablo63
Thu July 22, 2010 7:15pm
|
Present project to be completed by Spring 2011
|
|
pablo63
Thu July 22, 2010 7:15pm
|
Present project to be completed by Spring 2011
|
|
pablo63
Thu July 22, 2010 7:15pm
|
Present project to be completed by Spring 2011
|
|
Jac Mac
Tue April 12, 2011 10:35pm
Rating: 10
|
9 inch Ford Independent rear center section.
9 inch Ford Diff assy, mounts on 4 pads on rear of housing plus 'ring' bracket that attach's to pinion retainer. This particular unit has now completed seven hard seasons of classic racing in a TVR Tuscan. We are now upgrading the axle shafts to 35 spline to make it totally bulletproof...if such a state ever exists!:)
|
|
Wbulk
Tue August 23, 2011 6:51pm
Rating: 10
|
302 Engine
Just completed the engine breakin
|
|
nanard289
Fri December 30, 2011 1:55pm
|
Step 5
Welding operation is completed, now we have to adjust both intake manifold ports to the head cylinder
|
|
