TWOOD
Mon September 1, 2008 3:51pm
|
Same bracket back to back with irregular side on frame
This position permits the irregular ear side of the bracket to fit around the shock tower and any of the holes can align with the slots in the frame.
|
|
bermblaster41
Sun November 30, 2008 5:03am
|
DSC00206_Medium_
Position where collector should be
|
|
sambo
Tue February 3, 2009 3:57pm
|
|
Austin_Snake
Thu February 19, 2009 11:24am
Rating: 10
|
On_lift
LIft on Jackstands for lower position
|
|
frdfver
Fri April 10, 2009 4:48pm
|
N.A.F. Build
Setting up car to position and square rear axle in car for Satchell Link Suspension build. Its not the tools that you have to use.....but how you use the tools that you have.
|
|
frdfver
Fri April 10, 2009 4:48pm
|
N.A.F. Build
Setting up car to position and square rear axle in car for Satchell Link Suspension build.
|
|
frdfver
Fri April 10, 2009 4:49pm
|
N.A.F. Build
Setting up car to position and square rear axle in car for Satchell Link Suspension build.
|
|
frdfver
Fri April 10, 2009 4:49pm
|
N.A.F. Build
Setting up car to position and square rear axle in car for Satchell Link Suspension build.
|
|
martrogers
Tue July 21, 2009 2:02am
|
rear showing aerial position
|
|
Pete Munroe
Wed July 22, 2009 9:58pm
Rating: 10
|
ERA 289 FIA shoulder harness mount
Roll bar mount for raising the shoulder harness. Moved one of the belt anchors to the outside of the roll bar. For the inside anchor I welded a bracket on the bar. Point was to be symmetrical to where I mounted the seat. Did not mount the seat as suggested in the "offset" position. Wanted it directly back from the pedals. Did lose some leg room by not doing the normal "offset".
|
|
martrogers
Fri October 2, 2009 11:59pm
|
ac4
Logo in position, just need to remove tape and fix from the underside (which means taking out radiator, draining down etc)
|
|
Wbulk
Tue April 13, 2010 5:37pm
Rating: 10
|
Modified B and B Suspension Mounts
This was to correct a defect on some cars sold in 2009. The lower tubes were raised to the proper position in the picture. The upper mounts were redesigned and raised to accept a longer shock. This corrected bump steer, roll center and shock travel issues.
|
|
krausewich
Sat May 22, 2010 6:10am
|
Moch engine positioned aft of stock location and 'Plan B' framework added
Moch engine positioned aft of stock location and 'Plan B' framework added
|
|
Wbulk
Tue August 10, 2010 4:36pm
Rating: 10
|
Trunk Latch
The position of the latch handle sets license plate spacing.
|
|
Wbulk
Tue August 10, 2010 4:40pm
Rating: 10
|
Rear Trunk Latch
The position of the latch handle sets license plate spacing between the light and the handle.
|
|
