fastraxsg
Tue April 21, 2009 3:59am
|
|
fastraxsg
Mon May 18, 2009 6:41am
|
|
fastraxsg
Wed May 20, 2009 8:45am
|
welding blind
I took this photo in Singapore in the early 80's. I doubt Ho Siang is doing this anymore. His answer to any question was "no problem."
|
|
fastraxsg
Wed September 30, 2009 6:18am
|
|
fastraxsg
Wed September 30, 2009 6:18am
|
|
fastraxsg
Tue December 29, 2009 6:55am
|
rear
Trunk tub with side supports finished for tub.
|
|
fastraxsg
Tue December 29, 2009 6:55am
|
trunk_tub
Top fill for gas tank, fills from inside trunk. Too easy for stones and such in the gas tank or someone to borrow fuel with LeMans filler. Outside cap will be for show only.
|
|
fastraxsg
Mon October 4, 2010 7:23pm
Rating: 1
|
Inspection holes
Cut two holes in trunk tub to use for inspection holes, will make a double layer plug to fill them, bottom layer will fill the hole, top layer will over lap sides of hole to keep the weather out.
|
|
fastraxsg
Mon October 4, 2010 7:26pm
|
motor mounts
Had a serious problem with ground clearance so raised the motor up in the chassis and a tab forward to clear local monster speed bumps and deep potholes.
|
|
fastraxsg
Mon February 21, 2011 7:09am
|
Shift Linkage
TH 350 shift linkage sticks in a bit into the seat tub so make a chicken wire frame to cover with aluminum foil and then several layers of glass cloth.
|
|
fastraxsg
Mon February 21, 2011 7:09am
|
Shift Linkage Cover
Linkage cover trimmed and finnished. Will screw in then velcro a carpet cover over it.
|
|
fastraxsg
Mon February 21, 2011 7:09am
|
Shifter platform
TH 350 Lokar linkage sits up high, fab'ed a glass riser and then glassed in after the photo was taken. Also glassed in area behind shifter.
|
|
fastraxsg
Mon February 21, 2011 7:21am
|
Progress
Hurricane 1081 SBC 350, TH 350
|
|
fastraxsg
Mon April 4, 2011 7:54am
|
|
fastraxsg
Tue April 19, 2011 9:17am
|
front end
People keep telling me I put the motor in backwards...go figure.
|
|
