Clois Harlan
Mon March 9, 2009 6:32pm
|
Hand laid Fiberglass
This is where the body begins
|
|
Pete Munroe
Wed July 22, 2009 9:58pm
Rating: 10
|
ERA 289 FIA shoulder harness mount
Roll bar mount for raising the shoulder harness. Moved one of the belt anchors to the outside of the roll bar. For the inside anchor I welded a bracket on the bar. Point was to be symmetrical to where I mounted the seat. Did not mount the seat as suggested in the "offset" position. Wanted it directly back from the pedals. Did lose some leg room by not doing the normal "offset".
|
|
stiffy
Mon October 5, 2009 4:17pm
|
|
stiffy
Wed October 21, 2009 2:23pm
|
|
Mark IV
Sun November 8, 2009 12:42pm
Rating: 10
|
Where SPF's come from, when two people love each other.....
|
|
Silverback51
Tue December 29, 2009 8:14am
Rating: 10
|
DSC_0255a
Where the shock had worn on the A-Frame
|
|
Beejay
Mon April 26, 2010 4:29am
Rating: 10
|
Cobra Rebuild
Where did that clutch bolt go?
|
|
Wbulk
Sat May 15, 2010 6:40am
Rating: 10
|
Full Roll Bar Home Built
2", .120 wall tubing designed to be chromed. You have to allow for chrome thickness where the tubes slid together. A lot more work than I thought. $175 invested so far. Bending and chrome brought the cost up to about $400.
|
|
Wbulk
Fri June 25, 2010 3:14pm
Rating: 10
|
Port Matching Edelbrock Intake to Heads
This is showing the area where aluminum has to be removed from the intake to match the ports on the heads.
|
|
Z-linkCobra
Mon October 11, 2010 6:21am
|
Top end oiling plumbing
Got the valve covers plumbed in.....im trying to figure out where the put the gold in those little #4 an fittings.
|
|
Wazza
Sat August 6, 2011 9:27pm
|
I THINK I see where the crack is !!
A small tug on the block when we were taking it off the stand...and there wasn't much holding it together anymore.
|
|
cobrajeff
Fri December 28, 2012 3:37am
|
Pantera at Street Machine Nationals
I drove my Pantera to the Car Craft magazine Street Machine Nationals in Niagra Falls, NY, where it won first place in the Sports Car class.
|
|
Earl J
Mon April 14, 2014 2:03pm
|
Return Spring and mounting bracket
I thought this was rather clever of me. That bracket curves around and clears the distributor body where I drilled and tapped a 10/31 heim joint for the dual return spring to connect. There is no binding on the return spring as well.
|
|
52chevyred
Sun May 18, 2014 4:34pm
Rating: 10
|
Front of Hinge cut at 3/4"
Here is where the "original hinge" is cut, 3/4" inch, after the hinge pin. This is on the "front side", before the pipe is installed.
|
|
EarlsflyinCobra
Wed June 25, 2014 11:38am
|
Top of hood
Outlined area is where the hood hits the intake, hood scoop is 23 1/2" long, 14 1/2" wide in the front, 13" wide in the back, and 1 7/8" high in the center.
|
|
