 
Main Menu
|
|
Nevada Classics
|
|
Advertise at CC
|
| S |
M |
T |
W |
T |
F |
S |
| 1 |
2 |
3 |
4 |
5 |
6 |
7 |
| 8 |
9 |
10 |
11 |
12 |
13 |
14 |
| 15 |
16 |
17 |
18 |
19 |
20 |
21 |
| 22 |
23 |
24 |
25 |
26 |
27 |
28 |
| 29 |
30 |
31 |
|
|
|
|
|
|
CC Advertisers
|
|
|
|
|
|
|
|
|
For Sale By
|
Views
|
Date Posted
|
|
GASKETBOY
|
2911
|
Sat August 30, 2008
|
|
|
|
|
Asking Price
|
Condition
|
|
SOLD! (Best Offer)
|
Great
|
|
|
|
|
|
|
|
Description:
|
427SC manufactured by Hi-Tech (Phoenix AZ.)
Car is on its way to northern Michigan.
Titled as a 1965 Ford in Arizona
Overview:
You would be hard pressed to tell this car apart from a CSX4000 series, well, except for the price. Glass body with bolt on scoop – all body and door edges are rolled over per original aluminum cars. All lights, switches, emblems, hinges, carb linkage, hood, door and trunk latches etc are period correct.
• Guardsman Blue with Wimbledon white stripes
• 4” round tube frame based off original blueprints.
• Tubular upper and lower front control arms
• Independent rear suspension: 9" Ford center section
• Wilwood brakes - 12" rotors w/ Superlite calipers
• Coil over shocks at all 4 corners
• Chrome roll bar
• Dashboard braces
• Trigo polished pin drive wheels with stainless steel knockoffs
• Custom wiring by Arizona Street Rods
Engine:
428 Cobra Jet
Installed in January, 2008 – currently has 1,250 miles on it. Professionally machined (Hewes Performance - Reno Nevada), it is loaded with the best of parts, starts at the turn of the key and has great oil pressure. Realistic power is estimated at 425hp.
• Cobra Jet service block with correct internal ribbing; oiling mods done, deburred
• Edelbrock alum heads (ported and matched)
• 428CJ crank
• Eagle forged H-Beam rods
• JE forged pistons – approx 10:1 pump gas friendly compression ratio
• Rotating assy balanced
• ARP main, head, and rod bolts
• Clevite bearings
• Comp Cam Extreme Energy XE274 series hydraulic cam
• Precision Oil Pumps roller rocker setup with hardened shafts and billet end stands
• MSD ignition – distributor, coil, 6AL, wires
• Canton road race oil pan – 8 quart
• Edelbrock Performer RPM intake (matched to heads)
• 750cfm carb - Proform HP style
• Turkey pan and correct Hellings & Stellings Air cleaner
• Cobra Lemans valve covers
• Edelbrock Victor Series water pump
• Thunderbird style expansion tank
Transmission:
• 4 speed Toploader
• Centerforce Gold clutch and pressure plate
• Centerforce Aluminum flywheel
• ARP flywheel bolts
• Roller pilot bearing
• Correct reverse canted Mustang shifter
• Hurst linkage
Interior:
• Leather seats & Dash panel
• Autometer Cobra series gauges w/ reverse speedo
• Moto Lita steering wheel
• AC pedals
• Black carpet
• Fresh air ducting to foot wells
Misc.
• Jet Hot coated side pipes and header pipes.
• Ron Davis aluminum radiator with Spahl (Shelby) thermostatically controlled electric fan – does not overheat even in Phoenix summers.
• Girling master cylinders for clutch and brake with Girling reservoirs under hood
• Mocal oil cooler
• ALL lines are braided with AN fittings
• Aluminum paneled trunk
• Dual Stewart Warner electric fuel pumps in trunk – SC style
• Dual 6-Volt Optima red-top batteries mounted behind passenger seat with cutoff switch as per original SC cars.
• Functional wipers
Hi Tech was known for producing very accurate replicas. This is NOT a live axle, Mustang II or Fox body donor car – it is a very accurate, high end replica that has been built right and maintained well. You can still eat off the underside after 7-1/2 years on the road. The car does get driven regularly in the cooler weather and has several rock chips so it is not a show car.
|
|
Keywords:
|
427sc hi tech 428cj
|
|
|
|
|
|
Author
|
|
Great Asp
CC Member
Registered: February 2001
Location: St. Louis, Missouri
Posts: 1648
|
|
Comment Date: Sun August 31, 2008
|
|
Looks like a really nice car!
Good luck with the sale!
E
------------------------------
SPF 2715 w/ KC 496 FE
2014 GT500 Blk/Blk
|
|
|
|
SunDude
CC Member
Registered: July 2006
Location: Ottawa
Posts: 1622
|
|
Comment Date: Sun September 7, 2008
|
|
Very nice looking car!
When was it originally completed and/or licensed (month and year)?
The car has to be at least 15 years old for we poor ol' Canucks to import it.
Thanks.
------------------------------
"Anyone who drives faster than you is a Maniac,
and anyone who drives slower is an Idiot." - George Carlin
|
|
|
|
|
GASKETBOY
Club Cobra Member
Registered: February 2001
Location: Lake Elsinore
Posts: 343
|
|
Comment Date: Tue September 9, 2008
|
|
I believe it was in the fall of '99. I'm about 1,000 miles from home and all my records.
It is titled as a 1965 Ford Roadster if that helps.
|
|
|
|
|
|
All times are GMT -7. The time now is 09:12 AM.
Links monetized by VigLink |
;)
;)
;)
;)
;)
;)
